Assessment of Fire Safety for Intermediate Floors in the New Zealand Acceptable Solution C/AS1

dc.contributor.authorLe, Phung Van
dc.date.accessioned2010-06-07T21:31:18Z
dc.date.available2010-06-07T21:31:18Z
dc.date.issued2010en
dc.description.abstractThis research project aims to investigate the level of risk/safety inherent in intermediate floors of buildings designed to the Compliance Document for the New Zealand Building Code, Fire Safety Clauses C1, C2, C3, C4 (C/AS1), and develop guidance for Fire Engineers on designing fire safety for firecells containing intermediate floors. The project also aims to develop a new set of prescriptive fire safety requirements for intermediate floors and proposes an outline of a verification method for designing fire safety for intermediate floors. This study includes a literature review of the fire safety requirements for intermediate floors (mezzanines) of prescriptive requirements in New Zealand and other countries such as USA, Canada, UK and Australia. The results of this literature review found that the intermediate floor size is limited and varies with country. An intermediate floor that has an area exceeding the limit set out by the prescriptive requirements is considered as a storey in all the countries prescriptive requirements reviewed including the New Zealand prescriptive requirements prior to 1991. Since 1991, in New Zealand Acceptable Solutions, the intermediate floor that has an area exceeding the limit will not be treated as a storey, however, a smoke control system is required. The level of risk was quantified using a factor of safety (FoS) - the ratio of Available Safe Egress Time (ASET) to Required Safe Egress Time (RSET). Two fire models; BRANZFIRE and FDS were used to calculate ASET and SIMULEX, an evacuation program, was used to calculate movement times of the occupants of the studied buildings. Unlike the traditional method in which RSET and FoS are assessed using single value, in this project the distribution of RSET and FoS were assessed using the @RISK software package. The analysis showed that the level of risk to the occupants of the firecells containing intermediate floors is always higher than that of the equivalent firecells without intermediate floors with the same occupant load and the differences in FoS range from 10% to 60%. The analysis also highlighted that the level of risk to the occupants of firecells having intermediate floors increases as the intermediate floor size increases, however, there are no clear cut-off points at which a higher level of fire safety precaution should be provided. The cut-off points in C/AS1 of 20% for a closed intermediate floor and 40% for an open intermediate floor, are not justified by this analysis. Occupant load has significant impact on the level of safety of the occupants of the firecells containing intermediate floors. The higher the occupant load the lower the level of safety is. The definitions for open and closed intermediate floors are proposed to which open and closed intermediate floors are clearly distinguished. The term “limited area intermediate floor” in the current C/AS1 is proposed be removed and all related clauses are proposed to be amended or deleted accordingly. A proposed new set of prescriptive fire safety requirements for intermediate floors has been developed based on the occupant load of intermediate floors and not the intermediate floor size in the form of a table similar to the current Table 4.1 of C/AS1. The occupant load and fire safety precautions (FSPs) of the intermediate floors are determined based on the occupant load and their required FSPs of the equivalent firecells without intermediate floors that have the same factor of safety with the firecells containing intermediate floors. With the proposed FSPs, a firecell with lower occupant load would require lesser fire safety requirements than a firecell with higher occupant load regardless of intermediate floor size. Moreover, with the proposed FSPs for intermediate floors, the level of safety of the occupants of the firecells having intermediate floors would be very similar to the level of safety of the equivalent firecells without intermediate floors. In addition to the proposed tables of FSPs, some clauses regarding the changes in the fire safety requirement and definitions for intermediate floors are proposed. Guidance for designers in designing fire safety for firecells containing intermediate floors in which the methods of modelling using BRANZFIRE and Fire Dynamics Simulator (FDS) are presented in detail, has been developed. The analysis has pointed out that the location of the exits is critical in designing fire safety for firecells containing intermediate floors and majority of exits from the lower floor should not be located under intermediate floors. Although one of the main objectives of this research project was to propose an outline of a verification method for designing fire safety for intermediate floors, the analysis showed that it is very difficult to develop a rational verification method for designing fire safety for firecells containing intermediate floors. Using the proposed FSPs for intermediate floors which are based on the occupant load of the intermediate floors in designing fire safety for firecells containing intermediate floors is recommended by this study. These recommendations do not preclude the use of specific fire engineering design for designing fire safety for firecells having intermediate floors.en
dc.identifier.issn1173-5996
dc.identifier.urihttp://hdl.handle.net/10092/3942
dc.identifier.urihttp://dx.doi.org/10.26021/3246
dc.language.isoen
dc.publisherUniversity of Canterbury. Civil and Natural Resources Engineeringen
dc.relation.isreferencedbyNZCUen
dc.rightsCopyright Van Phung Leen
dc.rights.urihttps://canterbury.libguides.com/rights/thesesen
dc.subjectIntermediate Flooren
dc.subjectFire Safety Precautionen
dc.subjectOccupant Loaden
dc.subjectRisken
dc.subjectC/AS1en
dc.titleAssessment of Fire Safety for Intermediate Floors in the New Zealand Acceptable Solution C/AS1en
dc.typeTheses / Dissertations
thesis.degree.disciplineFire Engineeringen
thesis.degree.grantorUniversity of Canterburyen
thesis.degree.levelMastersen
thesis.degree.nameMaster of Engineering in Fire Engineeringen
uc.bibnumber1330442en
uc.collegeFaculty of Engineeringen
Files
Original bundle
Now showing 1 - 1 of 1
Loading...
Thumbnail Image
Name:
thesis_fulltext.pdf
Size:
3.56 MB
Format:
Adobe Portable Document Format