The Hydrogeology and Hydrochemistry of the Mt. Tom Price Mine, Pilbara, Western Australia – A Groundwater Flow Model.

dc.contributor.authorManewell, Neil
dc.date.accessioned2010-08-31T02:48:17Z
dc.date.available2011-03-22T11:20:06Z
dc.date.issued2008en
dc.description.abstractThe Mt. Tom Price Mine, located in the Pilbara region of Western Australia, has been the site of major iron ore mining since the 1960s by Rio Tinto Iron Ore/Pilbara Iron. The thesis project area covers approximately 121 km², covering the Mt. Tom Price Mining area and the surrounding catchment boundary. The climate in the Pilbara region is arid, with rainfall driven by seasonal cyclonic events, producing 300 mm/year net rainfall on average. The geology of the Mt. Tom Price area consists of a series of banded iron formations (BIF) and shales that are generally low in hydraulic conductivity values. Iron ore in the region is produced through the process of supergene enrichment whereby gangue minerals are dissolved and replaced with haematite and goethite. Mining is focused in a series of open cast pits including, North Deposit, West Pits, Centre Pits, Southern Ridge, South East Prongs, Section Six, Section Seven, and the proposed Marra Mamba Pits. Due to the impermeable nature and complex geology of the BIF sequence, groundwater flow is dominated by bedrock aquifer flow, with compartmentalization occurring in several areas of the mine. Highly faulted and folded units can also have increased hydraulic conductivity values. Pit floor lowering began to encounter the regional water table in early 1994. A series of dewatering bores and depressurization measurements have been utilized to ensure dry mining practice. This data was used to help understand regional groundwater flow and create the Mt. Tom Price Groundwater Model (MTPGM). A 3D geological model of the project area was created to aid visualisation of semi-regional hydrogeology. From this model, accurate template files were created so that geological detail loss is kept to a minimal when entering hydrogeological parameters into the MTPGM. The MTPGM was setup using PMWIN Pro, a graphical user interface for use with MODFLOW. Stresses such as recharge and pumping were entered via software packages within MODFLOW. The model was run to simulate measured 1994-2007 responses to dewatering and high rainfall events. A Parameter Estimation (PEST) software package and trial and error calibration was used to lower stress response variances that were observed in the model output files. This was achieved by the adjustment of hydrogeological parameters such as hydraulic conductivity and specific yield values. A prediction simulation of final pit lake recovery was created Using the calibrated MTPGM. Recovery curves predicted that full recovery of the water table of the pit voids varied from 96 to 120 years, recovering to levels close to the initial heads measured in 1994 before large-scale pumping commenced. The hydrochemistry of the groundwater in the mining area is highly influenced by geological hosts, with clearly defined hydrochemical signatures approximated for each screened geological unit. Due to the sulphur rich, acid- forming Mt. McRae Shale, regular monitoring of pit and groundwater is essential. Final pit lake water quality was estimated using final pit levels and recovery rates approximated from the MTPGM, combined with historical data and previous groundwater quality reports. Pit lake water quality is dominantly driven by evaporation concentration, caused by high evaporation rates and low throughflow. Pit waters are expected to be brine waters (greater than 100,000 mg/L TDS), with high levels of acidity values occurring in the South East Prongs and Section Six pits due to the exposure of the acid forming Mt. McRae Shale above the pit lakes at these localities. Future studies should focus on more detailed modelling of the compartmentalised aquifer systems. This would produce much more accurate final pit lake levels. Further study of the Mt. McRae Shale formation and its implications on acidity should also be undertaken. Seasonal fluctuations in lake levels will affect acidity due to the continual re-exposure and oxidation of the Mt. McRae Shale. This could be studied to help understand short term pit lake quality conditions and help to predict long term acidity conditions in the pit lakes.en
dc.identifier.urihttp://hdl.handle.net/10092/4419
dc.identifier.urihttp://dx.doi.org/10.26021/2512
dc.language.isoen
dc.publisherUniversity of Canterbury. Geological Sciencesen
dc.relation.isreferencedbyNZCUen
dc.rightsCopyright Neil Manewellen
dc.rights.urihttps://canterbury.libguides.com/rights/thesesen
dc.subjectTom Priceen
dc.subjectHydrogeologyen
dc.subjectHydrochemistryen
dc.subjectPilbaraen
dc.subjectAustraliaen
dc.subjectGroundwater Modellingen
dc.subjectMODFLOWen
dc.titleThe Hydrogeology and Hydrochemistry of the Mt. Tom Price Mine, Pilbara, Western Australia – A Groundwater Flow Model.en
dc.typeTheses / Dissertations
thesis.degree.disciplineEngineering Geology
thesis.degree.grantorUniversity of Canterburyen
thesis.degree.levelMastersen
thesis.degree.nameMaster of Science
uc.bibnumber1131743
uc.collegeFaculty of Engineeringen
Files
Original bundle
Now showing 1 - 1 of 1
Loading...
Thumbnail Image
Name:
thesis_fulltext.pdf
Size:
10.24 MB
Format:
Adobe Portable Document Format
License bundle
Now showing 1 - 1 of 1
No Thumbnail Available
Name:
license.txt
Size:
2.94 KB
Format:
Item-specific license agreed upon to submission
Description: