Contact force and torque sensing approaches enable manipulators to cooperate with humans and to interact appropriately with unexpected collisions. In this thesis, various moving averages are investigated and Weighted Moving Averages and Hull Moving Average are employed to generate a mode-switching moving average to support force sensing. The proposed moving averages with variable time period were used to reduce the effects of measured motor current noise and thus provide improved confidence in joint output torque estimation. The time period of the filter adapts continuously to achieve an optimal trade-off between response time and precision of estimation in real-time. An adaptive Kalman filter that consists of the proposed moving averages and the conventional Kalman filter is proposed. Calibration routines for the adaptive Kalman filter interpret the measured motor current noise and errors in the speed data from the individual joints into. The combination of the proposed adaptive Kalman filter with variable time period and its calibration method facilitates force and torque estimation without direct measurement via force/torque sensors.

Contact force/torque sensing and response time assessments from the proposed approach are performed on both the single Universal Robot 5 manipulator and the collaborative UR5 arrangement (dual-arm robot) with differing unexpected end effector loads. The combined force and torque sensing method leads to a reduction of the estimation errors and response time in comparison with the pioneering method (55.2% and 20.8 %, respectively), and the positive performance of the proposed approach is further improved as the payload rises. The proposed method can potentially be applied to any robotic manipulators as long as the motor information (current, joint position, and joint velocities) are available. Consequently the cost of implementation will be significantly lower than methods that require load cells.