Villeneuve MCHeap MJKushnir ARLQin TBaud PZhou GXu T2018-08-142018-08-1420182195-9706http://hdl.handle.net/10092/15778Knowledge of the strength and elastic modulus of a reservoir rock is important for the optimisation of a particular geothermal resource. The reservoir rock for many geothermal projects in the Upper Rhine Graben, such as those at Soultz-sous-Forêts and Rittershoffen (both France), is porphyritic granite. High fracture densities (up to ~ 30 fractures/m) in this reservoir rock require that we consider the strength and elastic modulus of the rock mass, rather than the intact rock. Here we use uniaxial and triaxial deformation experiments performed on intact rock coupled with Geological Strength Index assessments—using the wealth of information from core and borehole analyses—to provide rock mass strength and elastic modulus estimates for the granite reservoir at Soultz-sous-Forêts (from a depth of 1400 to 2200 m) using the generalised Hoek–Brown failure criterion. The average uniaxial compressive strength and elastic modulus of the intact granite are 140 MPa (this study) and 40 GPa (data from this study and the literature), respectively. The modelled strength of the intact granite is 360 MPa at a depth of 1400 m and increases to 455 MPa at 2200 m (using our estimate for the empirical m i term of 30, determined using triaxial and tensile strength measurements on the intact granite). Strength of the rock mass varies in accordance with the fracture density and the extent and nature of the fracture infill, reaching lows of ~ 40–50 MPa (in, for example, the densely fractured zones in EPS-1 at depths of ~ 1650 and ~ 2160 m, respectively) and highs of above 400 MPa (in, for example, the largely unfractured zone at a depth of ~ 1940–2040 m). Variations in rock mass elastic modulus are qualitatively similar (values vary from 1 to 2 GPa up to the elastic modulus of the intact rock, 40 GPa). Our study highlights that macrofractures and joints reduce rock mass strength and should be considered when assessing the rock mass for well stability and rock mass deformation due to stress redistribution in the reservoir. We present a case study to demonstrate how a simple and cost-effective engineering method can be used to provide an indication of the in situ strength and elastic modulus of reservoir rock masses, important for a wide range of modelling and stimulation strategies. We recommend that the effect of macrofractures on rock mass strength and stiffness be validated for incorporation into geomechanical characterisation for geothermal reservoirs worldwide.en© The Author(s) 2018. This article is distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creat iveco mmons .org/licen ses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.BoreholeWellFracturesFailure criteriaJournal Article2018-06-22Fields of Research::37 - Earth sciences::3706 - Geophysics::370605 - Geothermics and radiometricsFields of Research::37 - Earth sciences::3706 - Geophysics::370604 - GeodynamicsFields of Research::40 - Engineering::4019 - Resources engineering and extractive metallurgy::401902 - Geomechanics and resources geotechnical engineeringhttps://doi.org/10.1186/s40517-018-0096-1